The purpose of this notification is to give you enough time for a purchase of a new toner cartridge set for your Dell Color 5110CN Laser Printer, in order to be avoided a non-operational printer's mode caused by a completely exhausted toner cartridge. Once the system detects that one or several toner cartridges are near the end of their useful life/print resource, you will see the following warning message ''Ready to Print NNN-NNN XXX Is Low''. If these steps do not correct the problem, please contact Dell Technical Support.The built-in monitoring system of your Dell Color 5110CN Laser Printer displays warning messages on the control LCD, when an abnormality/abnormalities has/have been detected. More info can be found in the 5100cn User’s Guide or the 5110cn User’s Guide.
If the error message persists, please contact Dell Technical Support. Reseat the fuser as shown above and check if the error message still occurs. 010-354 Restart Printer: please contact Dell Technical Support. A known-good fuser does not work: please contact Dell Technical Support. A known-good fuser works, or is not available: Call Dell to request a service Kit. Turn on the printer and check if the error still occurs. Reinstall the fuser, close the outer duplex assembly and reconnect the AC power cable. Grip the knobs on top of the fuser and gently lift the fuser out of the printer. Lift up the levers next to both ends of the fuser ( Figure 2). Press the right side latch button, and then swing open the outer duplex assembly ( Figure 1). Turn off the printer using the power switch on the right side and disconnect AC power. Allow time for the printer to cool before attempting to remove parts in this area. Reseat the fuser: How to Remove and Install the Fuser on the 5100cn Dell Laser Printer / How to Remove and Install the Fuser on the 5110cn Dell Laser PrinterĬaution: Do not touch inside the printer with your hands. For info on printing the report, please refer to the user manuals. If total impressions is approximately 100K or greater, Call Dell technical support. Print a Printer Settings Report and look for Total Impressions. If the error message persists, check the error on the printer LCD:. After the printer starts, check if the error message has cleared. Wait 10 seconds, then turn the printer on. 
Turn the printer off using the power switch on the right side of the printer.This article provides information on "How to Troubleshoot a 010-xxx Fuser Error on the 5100cn / 5110cn Dell Color Laser Printer"
0 kommentar(er)
